December 2002 TOSHIBA TEC
7 - 5
e-STUDIO160/200/250 SCANNER
7.3 Scanner Motor Operation
Rotation of the scanner motor is transmitted to carriages 1 and 2 via the timing belt and carriage drive
wire. First of all, carriages 1 and 2 moves to the home position. Home position is detected by carriage 1
passing the home position sensor. Carriages 1 and 2 then scan the original when the [START] key on the
control panel is depressed.
Timing belt 157
Wire roller
Scanner motor
Scanner motor pulley
Scanner drive gear
Scanner drive shaft
Wire roller
Carriage 2
Carriage 2 roller
Carriage 1
Wire
Timing belt 142
08-03-01
Summary of Contents for e-studio 160
