e-STUDIO160/200/250 DISPLAY UNIT
5 - 4
December 2002 TOSHIBA TEC
5.2.2 Display in the event of faulty conditions
No.
7
8
9
10
11
12
13
14
15
16
Message
Cassette 1 empty
Toner empty
Misfeed in bypass
Misfeed in copier
(Copier machine)
Misfeed in copier (LCF)
Misfeed in doc. feeder
(ADF)
Misfeed in finisher
(Finisher)
Misfeed in duplexer
(ADU)
Call for service
Time for maintenance
Condition of machine
Indication of lack of paper.
• Indicates when there is no paper
in cassette. A in Fig. 5-2-2.
• Bypass copying is possible.
Indication of lack of toner.
• B in Fig. 5-2-3 is displayed
when the toner in the toner
cartridge becomes empty.
• When this message is
displayed, it is not possible to
copy.
Bypass paper jamming (SFB).
• Paper jams at the bypass guide.
C in Fig. 5-2-4.
Paper jammed in the machine.
• D in Fig 5-2-5.
Cassette (LCF) paper misfeed.
• Paper supplied from the cas-
sette does not reach the align-
ing sensor in a set time.
E in Fig. 5-2-6.
Original jammed
• An original is jammed in the
ADF.
F in Fig. 5-2-7
Paper jammed in the sorter.
G in Fig. 5-2-8 .
Paper jammed in the ADU.
H in Fig. 5-2-9.
Some part of the mechanism, mo-
tors, switches or sensors is abnor-
mal.
Indication of PM cycle.
• Displayed when it is time for
preventive maintenance and
inspection.
• Capable of copying.
Notes
• Supply paper to the selected
cassette.
• Select another cassette.
• Reset after the toner is supplied
and the front cover is closed.
The machine returns to normal con-
ditions automatically when the pa-
per out is pulled from the bypass
guide.
Remove the paper jammed in the
copier by following the messages.
Remove the paper jammed in the
copier by following the message.
Open the ADF jam access cover
and the ADF unit, and remove the
jammed original.
Remove the paper jammed in the
sorter and open and close the front
cover for once.
Remove the paper jammed in the
copier by following the message.
Turn OFF the machine, remove the
cause of the fault and turn the ma-
chine back ON.
Maintenance and inspection by a
qualified service technician.
Summary of Contents for e-studio 160
