Toshiba e-STUDIO 161 Service Manual Download

Page: 46 / 124

7-16

e-STUDIO161 SIMULATIONS

Paper off-center adjustment

Used to adjust the positions of copy images on copy paper and the center offset position when
scanning the document.
(Operating procedure)
When this simulation is executed, the current set value is displayed. Enter the adjustment value with
the 10-key and press the [START] key, and the entered value is stored and a copy is made.
When the [INTERRUPT] key is pressed, the entered value is saved and the machine goes into the
sub code entry standby mode. When the [CA] key is pressed, the entered value is saved and the
simulation is terminated.
(When the set value is increased by 1, the position is shifted by 0.1mm.)
<Supplement>
When the adjustment value is increased, the image is shifted to the left. When the adjustment value
is decreased, the image is shifted to the right.

Supported for the installed models only. Skipped for the models without installation.

Note: When the adjustment value is too great, the outside area of shading may be scanned, resulting

in black streaks on copy paper.
When printing is made with manual paper feed, use A3 paper.

Document off-center adjustment

Used to make the document scan off-center adjustment.
(Adjustment range: 1 ~ 99, Default: 50)
*

When the adjustment value is increased by 1, the print image is shifted by 0.1mm to the left

when the scan start position is put on the upper side.

<Adjustment item>

Resist amount adjustment

Used to adjust the contact pressure of the machine resist roller and the ADF resist roller onto the
paper.
(Operating procedure)
When this simulation is executed, the current set value is displayed.
When the exposure mode key is pressed, the following set items are changed sequentially. Enter an
adjustment value with the 10-key and press the [START] key, and the entered value will be saved and
a copy will be made. (Adjustment range: 1 ~ 99, Default: 50)
When the [CA] key is pressed, the entered value is saved and the simulation is terminated.

Supported for the installed models only. Skipped for the models without installation.

ADF scanning position automatic
adjustment

Place the black chart so that it covers both the ADF scan glass and the OC glass. Close the OC
cover. When this simulation is executed, the current adjustment value is displayed as the initial
display. When the [START] key is pressed, the mirror unit scans from the home position to the ADF
scan position with the current adjustment value displayed, and the ADF glass cover edge is
calculated from the difference between the ADF glass cover edge and the OC side document glass
CCD output level.
*

The default is 50, the adjustment range is 1 ~ 99, and the adjustment unit 1= about 0.127mm.

If the adjustment is completed normally, the adjusted value is displayed. If not, the jam lamp lights up
with the current set value displayed. When the [START] key is pressed again with the jam lamp ON,
the execution is repeated again. When the [Interrupt] key or the [CA] key is pressed during execution,
"- -" is displayed and the operation is canceled. The mirror returns to its home position and the
simulation mode is terminated. In the case when the [Interrupt key] is pressed, the machine goes
into the sub code input standby mode. In the case when the [CA] key is pressed, all the lamps are
turned off.

HSYNC output check

When the [START] key is pressed, HSYNC is performed and the polygon motor is rotated for 30 sec.
Every time when HSYNC is detected, the zoom lamp is lighted for 100msec.

Main
code

Sub

code

Contents

Details of operation

Lighting lamp

Adjustment mode

AE, Main cassette lamps
AE, 2nd cassette lamps
AE, Manual paper feed lamps
TEXT, main cassette lamps

Print center offset (Main cassette paper feed)

Print center offset (2nd cassette paper feed)

Print center offset (Manual paper feed)
2nd print center offset (Main cassette paper feed)

Lighting lamp