MY-1022
OPTION MY-1022 (250 sheets paper feed unit)
14 – 4
(12) Set the paper tray side plate.
Hold the grip of the paper tray side plate to slide it and set it according
to the paper size to be used.
(13) Fit the paper tray rear end plate.
Fit the paper tray rear end plate to the position of the paper size to be
used.
• Insert the power plug of the copier to the outlet and turn on the main
switch of the copier. Then, carry out the following procedure.
(14) Load paper into the paper tray.
Do not exceed the maximum height line.
(15) Check for center displacement.
Set an original on the document glass and copy it using a paper tray in
the copier.
Then, copy an original using the attached optional paper tray.
*
If the center of the copy image from the tray in the copier is different
from that of the copy image from the optional paper tray, execute sim-
ulation 50-10 to carry out adjustment.
Note: To make the paper center shift adjustment and the lead edge
adjustment, insert the power plug of the copier into the
power outlet, turn on the power switch, and perform the fol-
lowing procedure.
(16) Perform the center shift adjustment.
Set a document on the document glass and make a copy.
*
If the image center is shifted, perform the following procedure.
1. Execute SIM 50-10 with the key operations on the copier.
2. Turn on the Auto lamp and the lamp of a corresponding tray by
Light and Dark key, Enter the set value with the keys on the opera-
tion panel to perform the center shift adjustment, make a copy
again, and check that the center is not shifted.
• When the set value is increased, the image is shifted to the rear
side.
• When the set value is decreased, the image is shifted to the front
side.
After completion of the adjustment, press the
key to cancel the
mode.
(17) Perform the lead edge adjustment.
Set a document on the document glass, and make a copy.
1. Execute SIM 50-1 with the key operations on the copier.
2. Turn on the Auto lamp and the lamp of a corresponding tray by
Light and Dark key, Enter the set value with the keys on the opera-
tion panel and make a copy to check that the lead edge is within the
specified range.
• When the set value is increased, the copy image moves forward.
• When the set value is decreased, the copy image moves back-
ward.
After completion of the adjustment, press the
key to cancel the
mode.
[Program key]
/
/
key
Paper output direction
Front side
Printing side
Rear side
Center line of image
Center line
of paper
Output direction
1
Leading edge
Printing side
Printing side
Output direction
Center line
of paper
Leading edge
Center line of image
1
[Program key]
/
/
key
