e-STUDIO202S SIMULATION, TROUBLE CODES 10 - 15
50
12
Document off-center adjustment
The document scan off-center adjustment is performed.
The adjustment mode is changed over with the exposure select key. (Adjustment range: 1 – 99, Default: 50)
When the adjustment value is increased, the print result is shifted to the left.
51
02
Resist quantity adjustment
Used to adjust the contact pressure of paper against the machine resist roller and the RADF resist roller.
(Operating procedure)
When this simulation is executed, the current setup value is displayed.
Enter the adjustment value and press the START key, the entered set value will be saved and a copy will be made. When the
clear key is pressed, the entered value will be saved and the machine will exit from the simulation mode.
The exposure select key is used to select the mode.
53
08
ADF scan position automatic adjustment <ADF model only>
Place three sheets of white paper so that they cover the ADF scan glass and the OC glass, and execute the simulation with
the OC cover open, the mirror unit scans from the home position to the ADF scan position to identify the ADF glass cover
edge position by the difference in the CCD output levels of the ADF glass cover edge and the OC side document glass.
Default is 50. Adjustment range is 0 – 99. Adjustment increment: 1 = about 0.127mm
In the case of AUTO, when START key is pressed, the mirror unit scans from the home position to the ADF scan position with
the current adjustment value displayed. Then the ADF glass cover edge position is determined from the difference in the CCD
output levels of the ADF glass cover edge and the OC side document glass.
If the adjustment is completed normally, the adjusted value is displayed on the 7seg/LCD. If it is terminated abnormally, the
following lamp is turned ON.
"JAM lamp": When the operation is canceled by pressing C key during execution, the mirror is returned and "- -" is displayed.
The exposure select key is used to select the mode.
61
03
Polygon motor check (HSYNC output check)
(Operation/Procedure)
When the START key is pressed, HSYNC is performed and the polygon motor is rotated for 30 sec.
At that time, the Zoom lamp is lit for 100msec for every 3 times that the HSYNC is detected.
63
01
Shading check
Used to display the detection level of the white board for shading.
(Operating procedure)
When the START key is pressed, the mirror base unit moves to the white board for shading to light the copy lamp. Under this
state, the level of one pixel at the CCD center which is not corrected for 10sec in 1 sec, and the result is displayed on the value
display section.
Main
code
Sub
code
Content
: Supported only for installing models, and skipped for not-installing models.
Mode
Lamp ON
Default
Platen document scanning
AE mode lamp
50
ADF document front surface scanning
TEXT mode lamp
: Supported only for installing models, and skipped for not-installing models.
Adjustment mode
Lamp ON
Main cassette paper feed
AE, main cassette lamp
2nd cassette paper feed
AE, 2nd cassette lamp
Manual paper feed
AE, manual paper feed lamp
duplex back
TEXT, PHOTO, main cassette lamp
Mode
Lamp ON
Default
ADF scan position auto adjustment
AE mode lamp
50
ADF scan position manual adjustment
TEXT mode lamp
