e-STUDIO350/352/353/450/452/453
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 6
EAB0
Finisher jam (Saddle
stitcher unit)
Transport stop jam: The paper which passed
through the inlet sensor does not reach or pass
No.1 paper sensor, No. 2 paper sensor, No.3 paper
sensor or delivery sensor. [MJ-1024]
P. 5-48
EAC0
Transport delay jam: The paper which has reached
the inlet sensor does not pass through the inlet sen-
sor. [MJ-1024]
P. 5-49
EAD0
Other paper jam
Print end command time-out jam: The printing has
not finished normally because of the communica-
tion error between the SYS board and LGC board
at the end of printing.
P. 5-51
EAE0
Finisher jam
Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the fin-
isher.
P. 5-51
EAF0
Finisher jam (Finisher
unit)
Stack return jam: It cannot load the paper which
passed through the delivery roller on the intermedi-
ary process tray. [MJ-1022]
P. 5-46
EB30
Finisher jam
Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
P. 5-51
EB50
Paper transport jam
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 5-11
EB60
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 5-13
ED10
Finisher
(Puncher unit)
Skew adjustment motor (M1) home position detec-
tion abnormality: The Skew adjustment motor is not
at the home position. [MJ-1101 (when MJ-6101 is
installed)]
P. 5-52
ED11
Sideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
P. 5-52
ED12
Finisher
Shutter home position error: The shutter is not at
the home position. [MJ-1101]
P. 5-53
ED13
Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
P. 5-53
ED14
Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
P. 5-54
ED15
Paddle home position error: The paddle is not at the
home position. [MJ-1101]
P. 5-54
ED16
Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
P. 5-55
Error code
Classification
Contents
Troubleshooting
07/11
