e-STUDIO160/200/250 ADJUSTMENT ITEMS
1 - 18
December 2002 TOSHIBA TEC
1.2.3 User test mode
When you press the PROGRAM key and enter the TEST mode from the menu, the items that can be
tested by the user are displayed.
(1) AUTO TEST
This mode allows the user to independently diagnose the machine by automatically performing a
series of tests.
<Key used in operation>
<Display messages>
Test Items
a) Flash ROM test
Calculates and compares the check sums of the firmware, function data and
language information with the previously stored corresponding check sum
values.
b) SRAM test
Same as Function Test.
c) DRAM test
Same as Function Test.
d) MODEM test
Same as Function Test.
e) SCANNER test
Same as Function Test.
f) CODEC test
Same as Function Test.
g) Printer test
Checks each part of the printer (fan, HVPS, polygon, heater, LSU) and prints
one page of test pattern (not performed when there is no paper).
h) Phonebook data test Calculates and compares the check sum of the phonebook with the previ-
ously stored check sum value.
i) Network board test (with GF-1110)
PROGRAM
Select TEST MODE
Press the PROGRAM key
Auto test run
SET
SET
Select AUTO TEST
End of TEST
Use or keys
Use or keys
It takes about 2 minutes to
finish TEST
AUTO TEST
-------------------
AUTO TEST
Completed
PROGRAM
01.DEFAURT SETTINGS
02.LISTS
03.INITIAL SETUP
TEST MODE
01.AUTO TEST
02.INDIVIDUAL TEST
03.TEST RESULT LIST
