December 2002 TOSHIBA TEC
1 - 19
e-STUDIO160/200/250 ADJUSTMENT ITEMS
(2) INDIVIDUAL TEST
The user can perform a test in interactive mode and locate the faulty point from the test result. The test
result is printed in the form of a report.
<Key used in operation>
<Display messages>
Test Items
a) ADF test
Transports and ejects originals to check the transport system. Transports
and ejects a certain number of originals and displays the number of the
originals. The tester checks that this value matches the number of the origi-
nals. A transport speed can be selected with the resolution key.
b) Key test
Press all the keys on the operation panel to check if they are detected nor-
mally. The key test ends when the STOP key is pressed in the end. If there is
any key which is not detected when pressed before the STOP key is pressed,
it will be judged to be an error.
c) LED test
When the test is performed, all the LEDs will come on. If there is any LED
which is not lit when visually checked, it will be judged to be an error.
d) LCD test
All the dots on the display go off (turn black). When the Start key is then
pressed, all the dots light (turn white). If there is any dot which does not light
or go off when visually checked, it will be judged to be an error.
e) Speaker test
Check that the volume level from the speaker changes.
f) Sensor test
Sensor test.
Open and close the covers by following the guidance appearing on the dis-
play.
g) Printer test
Checks the printer function by printing two test patterns.
PROGRAM
Select TEST MODE
Press the PROGRAM key
Select item to be tested
SET
SET
Select INDIVIDUAL TEST
Use or keys
Use or keys
Selected test is performed
Use or keys
PROGRAM
01.DEFAURT SETTINGS
02.LISTS
03.INITIAL SETUP
TEST MODE
01.AUTO TEST
02.INDIVIDUAL TEST
03.TEST RESULT LIST
TEST MODE
07.TEST PRINT
TEST MODE
04.LCD TEST
05.SPEAKER TEST
06.SWITCH TEST
INDIVIDUAL TEST
01.ADF TEST
02.KEY TEST
03.LED LIST
CIS
SET
