e-STUDIO167/207/237
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 6
4.3.2
Description of abnormality
(A) Add paper
[In cases of the equipment drawer or the PFU / PFP drawer ] (When drawer is not installed)
•
Drawer empty sensor detects the presence or absence of paper.
No drawer detected
#
“Add paper” is displayed
The LED on the control panel corresponding to the drawer blinks (When the drawer is selected)
#
[START] button disabled
[In cases of the equipment drawer or the PFU drawer] (When the drawer is installed)
Drawer detected
#
Paper empty sensor OFF
#
“Add paper” is displayed
The LED on the control panel corresponding to the drawer blinks (When the drawer is selected)
#
[START] button disabled
[In case of the PFP drawer] (When the drawer is installed)
•
When the power is turned ON or the drawer is installed
PFP starts initialization
#
The detection of paper existence starts
Tray-up motor ON – Tray is raised
At this time, the tray-up sensor and paper empty sensor are OFF
%
When the tray-up sensor is not turned ON in a fixed period of time
Tray abnormality
%
“Add paper” is displayed regardless of the existence of paper
%
Cleared by turning the power ON and then OFF
%
The tray-up sensor is turned ON in a fixed period of time
- The tray-up motor is stopped.
At this time, if the paper empty sensor is
ON: It is judged that there is paper
OFF: It is judged that there is no paper
#
The lamp on the control panel corre-
sponding to the drawer blinks (When
the drawer is selected)