6
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO167/207/237
SCANNER
6 - 1
6.
SCANNER
6.1
General Description
In the scanning section, this equipment uses a CIS (Contact Image Sensor) for scanning the image.
The surface of an original is irradiated with light from the LED array mounted on the CIS unit and the
reflected light is scanned by the CCD where the optical image data are converted into an analog electri-
cal signal, and then transmitted to the MAIN board. After the binarization and the various image pro-
cessing operations necessary for image formation are performed on the MAIN board, the data are
transmitted to the writing section.
Fig. 6-1
Original glass
ADF original glass
Scan motor
CIS home position sensor
CIS unit
Original glass
ADF original glass
Scan motor
CIS home position sensor
CIS unit
Damp heater
Damp heater
Automatic original detection sensor
Automatic original detection sensor
Damp heater
Damp heater
Automatic original detection sensor
Automatic original detection sensor
LT series
A4 series