2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-48
(3) Select [05 ADJUSTMENT MODE]. Change the values for codes [7056] to [7058], [7061], [7062],
[7249] and [7794] to [7806] to adjust the default value for the sharpness intensity.
• Increasing the sharpness intensity will enhance the edges of the image.
• The smaller the setting value is, the weaker the sharpness intensity becomes. The larger the
setting value is, the stronger the sharpness intensity becomes.
Changing the values for these codes will change the sharpness intensity, when the [Sharpness]
indicator in the [Image] tab on the copy mode is set to the center. Remember that 1 step of the
indicator will increase or decrease the sharpness intensity by 25. If the sharpness intensity of the
center value is changed, each step of the indicator will be changed accordingly. (For instance, if
the center value is increased by “25” (sharper), the value of each step of the indicator will also be
increased by “25” (sharper).)
However, the range of adjustment values that is valid for sharpness level change is from -100 to
+100 of the total of the setting value of the [05] code and that of the indicator. For instance, if the
setting value of the [05] code is “153” (“+25” from the default value), the limit of the steps in the
sharp side of the indicator is “+3”. If the step is set at “+4”, the image quality will not be changed.
Color mode
Original mode
[05] code Recommended value
Acceptable
value range
Default
Full color
Text/Photo
05-7796
Set a value larger than
128.
0 to 255
128
Text
05-7797
Printed Image
05-7798
Photo
05-7799
Map
05-7800
User Custom
05-7795
Red Seal Color
05-7794
Mono color
Text/Photo
05-7801
Text
05-7802
Printed Image
05-7803
Twin color
Text/Photo
05-7804
Text
05-7805
Printed Image
05-7806
Black
Text/Photo
05-7056
Text
05-7057
Photo
05-7058
User Custom
05-7249
Image Smoothing
05-7061
Drop Out Color
05-7062
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......