2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-96
2.24.1
When adjusting the image quality of the Black mode
• Both the service technician and the user can perform step (1).
• Only the service technician can perform step (2).
(1) Press [Image] tab on the Copy mode and then press [ADF Noise Reduction].
Change the setting value of the noise reduction level.
After changing the setting value, perform printing and check its image quality.
If an additional image quality adjustment is necessary, perform the following steps.
(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7150] to [7152]
to adjust the noise reduction level.
• The smaller the value is, the larger the noise reduction level becomes. The larger the value is, the
smaller the noise reduction level becomes.
• When “0” is set for the setting value, this function becomes disabled.
After changing the setting value, perform printing and check its image quality.
Caution after the adjustment
Nothing in particular
Setting value
Description
None
The noise reduction function is disabled.
Low
The noise reduction level is low.
Middle
The noise reduction level is middle.
High
The noise reduction level is high.
Color mode Original mode [05] Code
Recommended value
Acceptable
value range
Default
Black
Text/Photo
7151
Set a value smaller than
100.
0 to 200
100
Text
7152
User Custom
7150
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......