1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1-14
• “Front” refers to the printed side in the simplex mode or the side that is delivered facing
downwards in the duplex mode.
“Back” refers to the printed side that is delivered facing upwards in the duplex mode.
• The table below shows you the acceptable paper weight for the paper type.
* e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
• After adjusting the transfer roller bias output, perform automatic calibration.
For further information regarding the procedures, refer to procedure (1) in "1.1 To Obtain a Darker
Image".
<Hint>
• The transfer voltage increases as the setting value is increased. It is usually desirable that the
setting value be decreased to obtain a clearly highlighted area.
After performing the adjustment, print and check the image quality.
If further image quality adjustment is necessary, go to step (3).
(2) If the image on the high density area looks grained on plain paper other than the TOSHIBA-
recommended one is used, select “recycled paper” as a paper type.
To select the paper type, refer to the Operator’s Manual for Paper Preparation Guide.
• If fine adjustment of image quality in the recycled paper mode is required in accordance with the
paper type, follow the steps from (a) to (b) below.
(a) Select [05 ADJUSTMENT MODE]. Change the value of the codes [2934] to [2937] to adjust
(2nd) transfer bias output. (In this step the transfer roller bias offset voltage is adjusted to
print the high density area or the Low/Middle density area of the image most clearly.)
Black Back
Plain/Thick
paper
05-2937
0
2 to 8
0 to 10
5
Thick paper 1
1
Thick paper 2
2
Thick paper 3*
3
Special paper 1
5
Special paper 2
6
Recycled paper
7
Thick paper 4*
8
Thin paper*
9
Envelope
10
Special paper 3*
11
Paper type
Acceptable paper weight
Plain paper
60 to 80 g/m²
16 to 21 lb. Bond
Thick paper
81 to 105g/m²
22 to 28 lb. Bond
Thick paper 1
106 to 163 g/m²
Max. 60 lb. Cover
Thick paper 2
164 to 209 g/m²
Max. 110 lb. Index
Thick paper 3*
210 to 256 g/m²
Max. 140 lb. Index
Thick paper 4*
257 to 280 g/m²
Max. 100 lb. Cover
Thin paper*
52 to 59 g/m²
14 to 16 lb. Bond
Paper type
[05] code
Sub
code
Recommended
value
Acceptable
value range
Default
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......