5.Scanning-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
© 2018 TOSHIBA TEC CORPORATION All rights reserved
5-26
When the noise reduction level for each [Low], [Middle] or [High] is changed, the service technician
must perform the following step.
(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7400] to [7404]
and from [8412] to [8415] to adjust the noise reduction level.
• Setting “200” provides the weakest noise reduction level, while setting “1” provides the strongest
one.
Moreover, when “0” is set for the setting value, this function becomes disabled.
• The noise reduction level for each [Low], [Middle] or [High] of [ADF Scan Noise Reduction] set
from the control panel is changed. Setting the recommended value provides the most effective
result.
After changing the setting value, perform scanning and check its image quality.
Caution after the adjustment
Perform the adjustment while checking the scanned images since the adjustment may decrease the
reproducibility of fine characters and lines.
Color mode
Original mode
[05] Code
Recommended
value
Acceptable
value range
Default
Black
Text/Photo
05-7401
90 to 120
0 to 200
100
Text
05-7402
Photo
05-7403
User Custom
05-7400
Full color
Text/Photo
05-8413
Text
05-8414
Photo
05-8415
User Custom
05-8412
Gray scale
---
05-7404
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......