1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1-32
• Example of phenomenon
The image on the trailing edge is tilted as shown below in the simplex mode.
When this tilted image is printed in the duplex mode, image positions on the front and back sides
become as shown below.
• Adjustment method
e-STUDIO2010AC/2510AC
Loosen the 2 screws [2] on the fuser unit guide rail (front). Remove 1 screw [3].
Change its position to the adjustment hole [4] and move the fuser unit guide rail (front) [2] up or
down.
(Guideline of the movement: One scale)
• There is a 0.5 mm wide scale at the position indicated by [5].
Front side
Rear side
Front side
Back side
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......