2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-8
(9) Select [08 SETTING MODE]. Change the value for subcode 3 of code [2548] to make the outline of
the copied text thicker and clearer, or thinner and finer.
• This adjustment can be made applicable to all colors by selecting the corresponding subcode. In
this step, however, change the setting value only for subcode 3 to adjust the image quality for the
black mode.
• To check the amount changed with this setting, it is recommended to set the value at “3” or “4” first
to decrease it, and then to set the value at “8” or “9” first to increase it. Then check the copy image
and increase or decrease the value further so that the image will be adjusted finely.
• After changing the value, perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image" to perform automatic calibration.
If further adjustments are necessary after performing step (9), you can repeat steps (1) to (8). When
repeating these steps, however, adjust the value while checking the copy image carefully.
(10) Select [08 SETTING MODE]. Change the value for subcode 3 or 7 of code [2620].
• This adjustment is available only for e-STUDIO2010AC.
• This adjustment also influences the printing and fax functions as well as the copying function.
Caution after the adjustment
The adjustment may possibly cause an increase in the amount of toner used, moiré, blurred text (small,
dark text blurred), faint text (fine outlines of text shredded) diminished photo images or gradational
images (less accurate reproducibility of halftones), or in some consumption conditions of consumables,
background fogging or a decrease in the amount of developer material (carrier streaks). Therefore,
carefully perform the adjustment while checking the copy image.
Setting item
[08] code Subcode
Recommended value
Acceptable
range value
Default
Potential on printing
white text / Correction
setting (K)
08-2548
3
To make the outline of text
thicker and clearer:
Set a value smaller than 5.
To make the outline of text
thinner and finer:
Set a value larger than 5.
0 to 12
6
Original mode
[08]code Subcode
Recommended
value
Acceptable
range value
Default
Text/Photo
Plain paper
Thick paper
Recycled
paper
Thin paper
08-2620
3
Set a value larger
than 15 to make the
text darker and
clearer.
8 to 36
15
Text
Photo
Image
smoothing
Text/Photo Thick paper
1/2/3/4
Special paper
1/2/3
Envelope
Transparency
(OHP film)
08-2620
7
Text
Photo
Image
smoothing
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......