2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-14
• After changing the value, perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image" to perform automatic calibration.
If further adjustments are necessary after performing step (8), you can repeat steps (1) to (7).
When repeating these steps, however, adjust the value while checking the copy image carefully.
(10) Select [08 SETTING MODE]. Change the value for subcode 0 to 7 of code [2620].
Caution after the adjustment
The adjustment may possibly cause an increase in the amount of toner used, moiré, blurred text (small,
dark text blurred), faint text (fine outlines of text shredded) diminished photo images or gradational
images (less accurate reproducibility of halftones), or in some consumption conditions of consumables,
background fogging or a decrease in the amount of developer material (carrier streaks). Therefore,
carefully perform the adjustment while checking the copy image.
Remarks
• Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality and a reduction in the life
of the consumables.
• If you perform only step (9) above (changing the setting value of code [08-2548]) as an image quality
adjustment for a certain color, it may cause an extra increase or decrease in the amount of the toner
used for this color compared with that for the other colors, or it may create a difference in the
reproducibility of halftones.
Color to
adjust
Original mode [08]code Subcode
Recommended
value
Acceptable
range value
Default
Y
Plain paper
Thick paper
Recycled
paper
Thin paper
08-2620
0
Set a value larger
than 15 to make the
text darker and
clearer.
8-36
15
M
1
C
2
K
3
Y
Thick paper 1/
2/3/4
Special paper
1/2/3
Envelope
Transparency
(OHP film)
08-2620
4
M
5
C
6
K
7
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......