2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-17
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
Use steps (a) through (d) to perform the adjustment.
(a) Press [Image] on Copy mode.
(b) Press [Color Balance] to adjust the color balance by changing the amount of toner (C, M, Y and
K) or [RGB Adjustment] to adjust the color balance by changing the intensity of R, G and B.
(c) Press [+] to enhance the tint of the color or [-] to decrease it.
• After selecting the color balance by changing the amount of toner (C, M, Y and K), press
[Detail]. The tint of the color can be adjusted according to density area (low, middle or high
density area).
(d) Press [OK].
After adjusting the tint of the colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7665] to [7671] to adjust
the hue.
• Set the value in increments of approx. 15 steps while checking the copy image until the optimum
value is obtained.
• Each setting value for the Text/Photo, Text and Photo (developing paper) original mode is
reflected to the quality of the image in the Full color and Auto Color modes.
• The subcode varies according to the area where the hue is adjusted. Set the subcode for the area
to be adjusted by referring to the following below.
Original mode
[05]code
Subcode
Recommended value
Default
Text/Photo
05-7665
0/1/2/3/4/5
0 to 255
128
Text
05-7666
Printed Image
05-7667
Photo
05-7668
Map
05-7669
User Custom
05-7670
Red Seal Color
05-7671
Subcode
Target area of hue
adjustment
Recommended value
0
For adjusting the tint of
Red
Setting a larger value: The tint of Red becomes closer to
that of Y (Yellow).
Setting a smaller value: The tint of Red becomes closer
to that of M (Magenta).
1
For adjusting the tint of
Yellow
Setting a larger value: The tint of Yellow becomes closer
to that of G (Green).
Setting a smaller value: The tint of Yellow becomes
closer to that of R (Red).
2
For adjusting the tint of
Green
Setting a larger value: The tint of Green becomes closer
to that of C (Cyan).
Setting a smaller value: The tint of Green becomes
closer to that of Y (Yellow).
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......