2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-23
2.5
To Copy in Vivid Colors
Explanation
When a copy is made without any adjustments, the vividness may be insufficient on the copy image.
Perform saturation adjustment, color adjustment (color balance adjustment or RGB adjustment), and
color density adjustment, in order to obtain a copy image in vivid colors.
Procedures
• You can start with any of the procedures other than (5). But it is recommended to perform the
procedures in order, as listed below. You can perform one procedure in conjunction with another. But if
this changes the image quality more than required or loses the effectiveness of the adjustment, restore
the settings made in the previously performed procedure to the original ones. Then perform other
procedures.
• Both the service technician and the user can perform procedures (1) to (3).
• Only the service technician must perform procedure (4) and (5).
• Only if the vividness of R (Red) is still insufficient even after procedures (1) to (4) have been used, the
service technician must perform procedure (6).
Before adjustment
After adjustment
When a copy is made without any
adjustments, the vividness is insufficient
on the copy image.
The copy image is obtained in vivid colors.
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......