2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-24
(1) Press [Image] tab on Copy mode. Press [One Touch Adjustment].
Press [Vivid] and then press [OK].
After selecting the “Vivid” option, copy and check the copy image quality.
When the copy image quality with the “Vivid” option is insufficient, cancel the “Vivid” option and
perform the next procedure.
(The one-touch adjustment can be canceled by pressing [Reset].)
(2) Perform saturation adjustment to adjust the overall saturation.
Use steps (a) through (d) to perform the adjustment.
(a) Press [Image] on Copy mode.
(b) Press [Saturation].
(c) Press [+] to increase the saturation of the copy image.
(d) Press [OK].
After adjusting the saturation, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
For further information regarding the adjustment procedures, refer to procedure (3) in "2.3 To
Closely Match the Color Balance of the Original"
After adjusting the tint of colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must perform the next
procedure.
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7675 to 7681] to adjust the
saturation level.
• Set the value in increments of approx. 15 steps while checking the copy image until the optimum
value is obtained.
• Each setting value for the Text/Photo, Text and Photo (developing paper) original mode is
reflected to the quality of the image in the Full color and Auto Color modes.
• The subcode varies according to the area where the hue is adjusted. Set the subcode for the area
to be adjusted by referring to the following below.
Original mode
[05]code
Subcode
Recommended value
Default
Text/Photo
05-7675
0/1/2/3/4/5
0 to 255
128
Text
05-7676
Printed Image
05-7677
Photo
05-7678
Map
05-7679
User Custom
05-7680
Red Seal Color
05-7681
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......