2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-29
(2) Select [05 ADJUSTMENT MODE]. Change the values for the following codes below to adjust the
density level of the background.
• The highlighted area will become highly visible, if the background density is increased.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
<Note>
• “Making the highlighted area more visible (or increasing the background density)” and “eliminating
the background color (or decreasing the background density)” are mutually contradictory. If the
background color is darkened to make the highlighted area more visible, the hue of the
background may change.
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(3) Press [Copy] on the [Home] screen. Press [
] to increase the copy density.
After increasing the copy density, copy and check the copy image quality.
With the copy density set to the maximum, if further image quality adjustments are still necessary,
the service technician must perform the next procedure.
Color mode
Original mode
[05] code Recommended value
Acceptable
value range
Default
Full color
Text/Photo
05-7656
Set 128 or larger.
0 to 255
128
Text
05-7657
Printed Image
05-7658
Photo
05-7659
Map
05-7660
User Custom
05-7661
Red Seal Color
05-7662
Mono color
Text/Photo
05-7707
Text
05-7708
Printed Image
05-7709
Twin color
Text/Photo
05-7710
Text
05-7711
Printed Image
05-7712
Black
Text/Photo
05-7100
Text
05-7101
Printed Image
05-7102
Image Smoothing 05-7105
User Custom
05-7106
Drop Out Color
05-7107
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......