2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-40
(4) Select [05 ADJUSTMENT MODE]. Change the values for codes [7190] to [7192], [7187], [7189] and
[7193] to adjust the gamma balance in each of the low and middle density area.
• Set the value in increments of approximately 20, while checking the copy image until the optimum
value is obtained. (Note that gradations (density level) in the middle and high density areas may
be reversed with some setting values.)
• Since the subcode varies according to the area where the density is adjusted, refer to the table
below and set the appropriate subcode. Remember that mainly adjusting the low or middle
density area will change the copy density of the images seen through the back of the page.
Adjusting the subcode 2 will allow you to adjust the high density area. But this will not solve the
problem. Therefore, never change the value for the high density area
.
Caution after the adjustment
The adjustment may possibly cause text handwritten with a pencil or light text to become illegible on the
copy. Therefore, carefully perform the adjustment, while checking the copy image.
Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality and a reduction in the life of
the consumables.
Original
mode
[05] code Subcode
Recommended value
Acceptable
value range
Default
Text/Photo
05-7190
0/1
Set a value smaller than
128.
0 to 255
128
Text
05-7191
0/1
Photo
05-7192
0/1
Drop Out Color 05-7187
0/1
User Custom
05-7189
0/1
Gray-Scale
05-7193
0/1
Subcode
Area where the density is adjusted
0
Low density area
1
Middle density area
Summary of Contents for e-STUDIO2010AC
Page 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Page 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Page 339: ......
Page 340: ......