6
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
6 - 3
E3C0
Paper transport jam
LCF transport jam (Paper not reaching the
registration sensor): Paper fed from the LCF and
passed through the 1st drawer feed sensor does
not reach the registration sensor.
E3D0
LCF transport jam (Paper not reaching the 1st
drawer feed sensor): Paper fed from the LCF and
passed through the 2nd drawer feed sensor does
not reach the 1st drawer feed sensor.
E3E0
LCF transport jam (Paper not reaching the 2nd
drawer feed sensor): Paper fed from the LCF and
passed through the LCF feed sensor does not
reach the 2nd drawer feed sensor.
E400
Cover open jam
Jam access cover open jam: The jam access cover
has opened during printing.
E410
Front cover open jam: The front cover has opened
during printing.
E420
Cover open jam
PFP side cover open jam: The PFP side cover has
opened during printing.
E430
ADU open jam: The ADU has opened during
printing.
E440
Side cover open jam: The side cover has opened
during printing.
E450
LCF side cover open jam: The LCF side cover has
opened during printing.
E480
Bridge unit open jam: The bridge unit has opened
during printing.
E4A0
Waste toner cover open jam: The waste toner cover
has opened during printing.
E510
Paper transport jam
(ADU section)
Jam not reaching the ADU entrance sensor: The
paper does not reach the ADU entrance sensor
after it is switchbacked in the exit section.
E520
Stop jam in the ADU: The paper does not reach the
ADU exit sensor after it has passed the ADU
entrance sensor.
E550
Other paper jam
Paper remaining jam on the transport path: The
paper is remaining on the transport path when
printing is finished (caused by a multiple paper
feeding).
E712
RADF jam
Jam not reaching the original registration sensor:
The original fed from the original feeding tray does
not reach the original registration sensor.
E713
Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment.
E714
Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
E721
Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
E722
Jam not reaching the original exit/reverse sensor
(during scanning): The original which passed the
read sensor does not reach the original exit/reverse
sensor when it is transported from the scanning
section to exit section.
Error code
Classification
Contents
Troubleshooting