FC-22 ADJUSTMENT
1 - 80
January 2000 © TOSHIBA TEC
1.16.2 Lens Unit
(a) Replacing the lens unit
· Since the lens unit was precisely adjusted at the factory, it must not be readjusted in the field or some
of its components must not be replaced. If necessary, the lens unit should be replaced as a unit.
· While replacing with a new lens unit, never loosen or remove the six screws indicated with arrows
below. They are locked with special paint.
· Use sufficient care when handling the lens unit. Never hold the precision-adjusted area of the lens unit.
Summary of Contents for FC22
