18
6. Voice cannot be transmitted to other party (outgoing call).
Can the base and handset be
connected?
See 3. The base and handset
cannot be connected.
OK
NG
T h e 1 k H z , 9 . 0 m V s i n e
wave fo r m i s a p p l i e d t o
MC601 + side, can the 1 kHz
sine waveform from pin 24 of
IC603 be fed?
Check Q604 and its
peripheral circuit.
NG
Check whether there is the
1 kHz sine wavefor m at
pin 23 of IC603.
Check IC603 and its
peripheral circuit.
NG
OK
OK
Check whether there is the
1 kHz sine wavefor m at
pin 20 of IC603.
Check IC603 and its
peripheral circuit.
NG
OK
TX output signal from the
handset is detected by the
liner detector, can the 1 kHz
sine waveform be fed?
Check RT603 or handset
RF unit.
NG
OK
Check whether there is the
1 kHz sine waveform at pin 9
of IC3 on the base unit.
Check IC3, Q1 and their
peripheral circuit.
NG
OK
Check whether there is the
1 kHz sine waveform at pin 3
of IC1.
Check RT2, Q2 and their
peripheral circuits.
NG
OK
Check whether there is the
1 kHz sine wavefor m at
pin 18 of IC1.
Check IC1 and its
peripheral circuit.
NG
OK
Check whether there is the
1 kHz sine waveform at the
Q3 collector.
Check Q3 and its peripheral
circuit.
NG
OK
Check whether the 1 kHz sine
wavefor m from TEL-line
output is fed.
Check T1, RL1 and their
peripheral circuits.
NG
OK
Check MC601 of handset.
Check base RF unit.
NG
OK
Summary of Contents for FT 8000
