3-4
3
Service Procedures
Accessing GA-1121 assembly components
In order to service the GA-1121, you need to shut down and open the copier. For
instructions, see other documentation included with the copier. Once the GA-1121
assembly is removed from the copier, you can access its components.
T
O
REMOVE
THE
GA-1121
ASSEMBLY
1.
Shut down the copier.
2.
Open the side of the copier so that you can access the GA-1121 assembly.
For details on opening the copier, see the other documentation included with the copier.
3.
Remove the network cable from the GA-1121 network port (see page 3-27).
4.
Pull the GA-1121 assembly about six inches out of the copier slot.
5.
Remove the power supply cable from the copier power supply (see page 3-7).
6.
Remove the Control Panel cable from the GA-1121 Control Panel (see page 3-7).
7.
Pull the GA-1121 assembly out of the copier.
