About this guide
vii
The
Service Guide
is intended for certified TOSHIBA GA-1121 (Fiery X3e+) and copier
service technicians servicing a GA-1121. If you have not received installation and service
certification, you should not attempt to install or service a GA-1121. Electronics for
Imaging, Inc. does not warrant the performance of the GA-1121 if installed or serviced
by non-certified personnel.
About this guide
This guide is divided into the following sections:
• “Preface”
Gives general information about this guide and general information that you should
know before you attempt to install or service the GA-1121.
• Chapter 1, “Introduction”
Provides general information about the GA-1121.
• Chapter 2, “Using the GA-1121 Control Panel”
Tells you how to use the Control Panel for GA-1121 functions, such as canceling print
jobs or printing Test and Configuration pages.
• Chapter 3, “Service Procedures”
Describes removal and replacement procedures for GA-1121 assembly components.
• Chapter 4, “Troubleshooting”
Identifies the source of common problems and suggests ways of correcting them.
• Appendix A, “Specifications”
Provides an overview of GA-1121 hardware specifications.
Customers should not use the technical service documentation. Do not leave this guide
behind after you make a service call.
About the illustrations in this guide
Illustrations in this guide reflect the GA-1121 assembly at the time of publication.
Components shown in these illustrations are subject to change. To receive information
about any components that do not match illustrations in this guide, contact your
authorized service support center.
Preface
