GD-1300 SIMULATION 4 - 1
[4] SIMULATION
1. Entering the simulation mode
To enter the serviceman simulation mode, press the keys as follows:
[#] key
→
[
∗
] key
→
[Clear] key
→
[
∗
] key
To cancel the simulation mode, press the [Clear All] key.
2. Key rule
3. List of simulations
[Numeric] key:
Entry of MAIN CODE/SUB CODE
Selection of an item
Setup of an adjustment value in case of simulations for adjustment
[
] [
] key:
Selection of MAIN CODE/SUB CODE
Selection of an item
[ENTER]/[OK]/[START] key: Settlement
<In case of simulations for print>
[ENTER]/[OK] key: Settlement (Without print)
[START] key:
Settlement/Print
[Clear] key:
(Interrupting operation check) Returns to the upper hierarchy.
In case of simulation of operation check, terminates the operations.
[Clear All] key:
Exits from the simulation mode.
For a simulation of adjustment, the display returns to the initial display (00-00).
Main
code
Sub
code
Contents
22
11
FAX-related counter display
24
10
FAX counter clear
46
12
Density adjustment in the FAX mode (Collective
adjustment)
13
FAX mode density adjustment (Normal text)
14
FAX mode density adjustment (Fine text)
15
FAX mode density adjustment (Super fine)
39
FAX mode sharpness adjustment
66
01
FAX soft SW setting
02
FAX soft SW initializing (excluding the adjustment
values)
03
FAX PWB memory check
04
Signal send mode (Max. value)
05
Signal send mode (Soft SW set value)
07
Image memory content print
Main
code
Sub
code
Contents
66
10
Image memory content clear
11
300bps signal send (Max. value)
12
300bps signal send (Soft SW set value)
13
Dial test
17
DTMF signal send (Max. value)
18
DTMF signal send (Soft SW set value)
21
FAX information print
24
FAST SRAM clear
30
TEL/LIU status change check
33
Signal detection check
34
Communication time measurement
37
Speaker sound volume setting
38
Time setting/check
