BASE STATION CONFIGURATION
Network Screen
3-8
IP4100 Install Sept., 2013
Network Screen
Figure 3-2 Network Screen
Table 3-8
IP Settings Parameters
Parameter
Description
DHCP/Static IP
Select whether this base station gets its IP address from a DHCP
server or uses a static IP address. Static address is recommended.
IP Address
(static IP address only) Enter the 32-bit IP address this base station
should use.
Subnet Mask
(static IP address only) Enter the 32-bit mask to specify which part of
the IP address identifies the network (255) and which part identifies
the node (0). Class A, B, and C networks use the following default
masks:
•
Class A: 255.0.0.0
•
Class B: 255.255.0.0
•
Class C: 255.255.255.0
Default Gateway
(static IP address only) Enter the IP address of the router that acts
as an entrance to the network or provides a default route for
communicating with hosts on remote networks.
DNS
(Primary and Secondary)
(static IP address only) Enter the IP addresses of the main (primary)
and backup (secondary) servers where this base station should
direct Domain Name System (DNS) queries.
