BASE STATION CONFIGURATION
Network Screen
IP4100 Install Sept., 2013
3-13
Note:
Firmware file versions are independent for each handset type. Be
sure you enter the correct version number for the specific type of
handset.
Note:
When the firware update is complete set this field to
0
.
If the required version field for any handset type contains a value
other than 0, clicking
Save
will start the firmware update process
for that handset type.
Table 3-15 Firmware Update Settings Parameters
Parameter
Description
Firmware update server
address
Enter the IP address or URL of the server that hosts the firmware update
files. This server must be available before starting an update.
Firmware path
Enter the path of the firmware update folder (see
Table 3-16 Update Handsets Parameters
Parameter
Description
Handset Type
If you have more than one hardware version or handset model on your system,
each detected handset type will be displayed here.
Required Version
Enter the version of the firmware that will be used to update each type of
handset. This field must match the last 3 digits of the name of the firmware file.
Table 3-17 Update Base Stations Parameters
Parameter
Description
Required Version
Enter the version of the firmware that will be used to update the
base station. This field must match the last 3 digits of the name
of the firmware file.
Update this base station only
Update the firmware on the currently connected base station.
Update all base stations
Update the firmware on all base stations in this system.
