GENERAL PRECAUTIONS FOR INSTALLATION/SERVICING/
MAINTENANCE
1. When installing the Paper Feed Pedestal KD-1009 to the Copier, be sure to follow the instructions
described in the “Unpacking/Set-Up Procedure for the KD-1009” booklet which comes with each unit of
the KD-1009.
2. The KD-1009 should be installed by an authorized/qualified person.
3. When transporting/installing KD-1009, employ two persons and be sure to use the positions as indi-
cated below. KD-1009 is fairly heavy and weight approximately 17 kg (37.5 lb), therefore pay full
attention when handling it.
4. Before starting installation, servicing or maintenance work, be sure to turn off and unplug the copier
first.
5. The KD-1009 is supplied with power from the copier, requiring no additional power source.
6. The KD-1009 should be grounded to the specified positions on the machine frame.
7. When servicing or maintaining the KD-1009, be careful about the rotating or operating sections such as
gears, pulleys, sprockets, cams, belts, etc.
8. When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise
noted in this manual or other related documents. Be careful not to reassemble small parts such as
screws, washers, pins, E-rings, toothed washers to the wrong places.
9. Basically, the machine should not be operated with any parts removed or disassembled.
10. Delicate parts for preventing safety hazard problems (such as thermofuses, door switches sensors,
etc. if any) should be handled/installed/adjusted correctly.
11. During servicing or maintenance work, be sure to check the nameplate and other cautionary labels (if
any) to see if they are clean and firmly stuck. If not, take appropriate actions.
12. Use suitable measuring instruments and tools.
13. The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband,
because the ICs on it may be damaged due to static electricity.
Caution: Before using the wrist band, pull out the power cord plug of the copier and make sure that
there is no uninsulated objects in the vicinity.
14. For the recovery and disposal of used KD-1009, consumable parts and packing materials, it is recom-
mended that the relevant local regulations/rules should be followed.
© Copyright 2000
TOSHIBA TEC CORPORATION
Summary of Contents for KD1009
