Connecting Hardware Devices
Maintenance overview
52
3
Grasp the handles on the server’s front panel, and carefully slide the server from the
rack until the rail latches lock the server in its fully extended position.
Sliding the server from the rack
4
To ensure that the server is locked in position, using light pressure, try to slide the
server back into the rack.
Sliding the server into the rack
1
Press the rail latches inward to release the server from its locked position, then slide
the server into the rack.
2
Tighten the two thumbscrews on the front panel to secure the server to the rack.
3
Reconnect any cables that were disconnected from the server.
Toshiba-supplied hardware items
The following table lists the hardware items that Toshiba provides with your server.
Type
Usage
Screw A
(metric)
Installing units except HDDs (or DAT) on the drive carrier or the rails.
Screw B
(SAE)
Installing HDDs or SCSI devices in the 5.25-inch device bay.
Installing the drive carrier on the server.
When installing devices, use the accessories that came with the devices. Use
this screw to replace missing screws.
Rail latch
Summary of Contents for Magnia 3310
Page 1: ......
