Connecting Hardware Devices
Memory modules
61
Installing memory modules
When upgrading system memory, place the first memory module in the lowest numbered
memory slot—slot 1B through slot 3A. If the memory modules are of different capacities,
place them in order of increasing capacity. Install the memory module with the smallest
capacity in slot 1.
Memory slots
1
If the server is in operation, shut it down, then remove the access panel. For detailed
instructions, read Steps 1 through 4 in
Maintenance overview
on page 50.
Never perform disassembly procedures that are not described in this manual.
Failure to observe this precaution could result in electric shock, cause a
system fault, or void your warranty.
Never install or remove memory modules immediately after turning off the
server. To avoid burn injuries, wait for the heat around the memory modules to
dissipate.
Installing a memory module while the server is on could cause damage to the
server or the memory module.
Memory modules can be seriously damaged by static electricity. Wear a wrist
or heel ground cable to discharge static electricity carried on your body. If such
equipment is not available, touch a grounded metal object to discharge static
electricity before working with sensitive electronic components.
Bank 1, memory slot 1B
Bank 1, memory slot 1A
Bank 2, memory slot 2B
Bank 2, memory slot 2A
Bank 3, memory slot 3B
Bank 3, memory slot 3A
Summary of Contents for Magnia 3310
Page 1: ......
