Connecting Hardware Devices
CPU module
78
5
While gently pressing the heat sink of the expansion CPU against the CPU socket,
simultaneously move both the left and right heat sink lock levers right in the direction
of the arrows, and hook the levers onto the claws to lock the heat sink in place.
Attaching and fixing the heat sink
Installing a 3.06 GHz CPU Module
For the following cases, the retention clamps (the parts attached to the heat sink) need to
be replaced.
❖
When the CPU module is initially added while in default status
❖
When a 2.40 GHz CPU module is removed and changed to a 3.06 GHz CPU module
Refer to
Replacing the Retention Clamp
on page 71 for details.
Installing and Removing Hardware
1
Connect the fan cable of the new heat sink to the fan connector (J6 for CPU1 and J7
for CPU2).
Do not push the fin section of heat sink of the CPU module. This may cause
the deformation of the heat sink.
Used heat sinks cannot be reattached. To replace a heat sink, contact your
Toshiba service station or sales representative. (Services will be provided for
a fee.)
Summary of Contents for Magnia 3310
Page 1: ......
