– 9 –
Operation section
Once the settings have been configured, all you need to do is push the
button from then on.
1
button (Fan speed select button)
Selects the desired Fan speed.
* Not available for the concealed duct high static
pressure and fresh air intake type. Only “High” is
displayed.
2
button (Timer set button)
Use to setup the timer.
3
button (TEST button)
Use only for service.
(During normal operation, do not use this button.)
4
button
Use when a ventilator (commercially-available) is
connected. Push the button to turn on/off the
ventilator. Turning on/off the air-conditioner also
turns on/off the ventilator.
*
No ventilator is connected if
“
” appears on
the remote controller display after pushing the
button.
5
button (Filter reset button)
Resets “
FILTER” indication after cleaning.
6
button (Power save operation)
Use to initiate power saving mode.
7
button
Use to select automatic swing or fixed louver
position.
* Not available for concealed duct, slim duct, floor
concealed and floor standing cabinet fresh air
intake types.
8
Operation lamp
Lights up during running.
Blinks when an error occurs or the protective
device activates.
9
button
Turns on the unit when pushed, and turns off when
pushed again.
10
button (Operation mode select button)
Selects desired operation mode.
1 8
3
5
2
9
10
6
7
12
4
11
SWING/FIX
11
button (Unit/Louver select button)
Selects a unit number (left) and louver number
(right).
UNIT button:
If two or more indoor units are controlled by one
remote controller, use this button to select a unit to
adjust its air blow direction.
LOUVER button:
(4-way cassette type only)
Selects a louver to control when adjusting the
louver lock setting or wind direction setting
separately for each louver.
12
button
Adjusts the set temperature.
Select the desired set point by pushing
TEMP.
or
TEMP.
OPTION:
Remote controller sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote controller can also be sensed. For details,
contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
1 8
3
5
2
9
10
6
7
12
4
11
UNIT LOUVER
17-EN
18-EN
