– 15 –
6
Push the
button to finish the setting.
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver
01 shown in the following figure is selected.
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
• When the air conditioner is stopped
• When heating starts
• When defrosting
• When thermo. off.
◆
Releasing the louver lock
Set “0000” in Step 4 of “Setting the louver lock”.
The
mark disappears.
* Steps 1 - 3 and 5, 6 of “Setting
the louver lock” also apply to
releasing the lock.
◆
Adjusting the horizontal direction
1
Push and hold the
and “TEMP.
”
buttons for at least 4 seconds while running
is stopped.
blinks.
“01” appears in CODE No.
2
Push the
button (left side of the button)
to select a unit
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to
change the CODE No. to “45”.
4
Push the “TIME
”buttons to select a
direction.
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push
button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
0001 - 0005
(Louver position
code)
Louver No.
03
01
02
04
Refrigerant
pipe
Drain pipe
Electrical control box
Direction SET
DATA
Direction setting
“0000”
Smudging reduction position
(reduces ceiling smudging)
(factory default)
“0002”
Cold draft position
(Less directly expose your body to
cool air)
0000
SET DATA
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
No display
4-way cassette type
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
▼
2-way and 3-way air discharge
The air discharge can be changed to the 2-way or 3-
way type to suit your room shape and style.
For details, contact the dealer where you purchased
the air conditioner.
2-way cassette type
1-way cassette type
(SH series)
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
▼
When cooling
Point the louver horizontally.
▼
When heating
Point the louver downward.
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
29-EN
30-EN
