ELECTRICAL ADJUSTMENTS
D-4
2-12: CENSOR SAW
1.
2.
3.
4.
5.
6.
7.
Receive the crosshatch signal from the Pattern Generator.
Press the MENU button. And, then press the LEFT/
RIGHT button on the remote control until the PICTURE
menu appears.
Press the UP/DOWN button on the remote control to
highlight DISPLAY FORMAT.
Press the LEFT/RIGHT button on the remote control to
select 1080i.
Set the screen mode to FULL.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (22) on the remote control to
select “C.SAW”.
Press the UP/DOWN button on the remote control until the
both ends vertical lines of the screen become parallel.
2-13: CENSOR PARA
1.
2.
3.
4.
5.
6.
7.
Receive the crosshatch signal from the Pattern Generator.
Press the MENU button. And, then press the LEFT/
RIGHT button on the remote control until the PICTURE
menu appears.
Press the UP/DOWN button on the remote control to
highlight DISPLAY FORMAT.
Press the LEFT/RIGHT button on the remote control to
select 1080i.
Set the screen mode to FULL.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (21) on the remote control to
select “C.PARA”.
Press the UP/DOWN button on the remote control until
the both ends vertical lines become straight.
2-14: TINT/COLOR CENT
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Receive the color bar pattern.
Connect the oscilloscope to TP806.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (53) on the remote control to
select "TINT".
Press the UP/DOWN button on the remote control until the
section "A" becomes as straight line.
(Refer to Fig. 2-3)
Connect the oscilloscope to TP805.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (49) on the remote control to
select "COL.CENT".
Press the UP/DOWN button on the remote control until the
red color level is adjusted to 120
±
10% of the white level.
(Refer to Fig. 2-4)
Please check whether the waveform of TP806 is straight
line. If is not a straight line, adjust to TINT again.
Receive the digital broadcast. (RF Input)
Perform the above adjustments 2~5.
Receive the color bar pattern. (VIDEO Input)
Press the INPUT button on the remote control to set to the
AV mode. Then perform the above adjustments 2~5.
Playback the DVD(480i ) disc. (COMPONENT Input)
Press the INPUT button on the remote control to set to the
YUV mode. Then perform the above adjustments 2~5.
Playback the DVD(480i) disc. (HDMI Input)
Press the TV/VIDEO button on the remote control to set to
the HD-MI mode. Then perform the above adjustments
2~5.
Fig. 2-3
100%
120%
"A"
Fig. 2-4
2-15: TINT
1.
2.
3.
4.
5.
Press the TV/VIDEO button on the remote control to set
to the DVD mode.
Connect the oscilloscope to TP806.
Playback the DVD(480i) disc.
Activate the adjustment mode display of Fig. 1-1 and
press the channel button (53) on the remote control to
select "TINT".
Press the UP/DOWN button on the remote control until
the section "A" becomes as straight line.
(Refer to Fig. 2-5)
Fig. 2-5
"A"
