MicroMAS Installation Guide
Installation
2
Micro MAS Installation Guide 4/07
Installation
Step 1: Before You Start
CAUTION!
Always handle this system with care. Avoid dropping or jarring the unit by
keeping the system in a secure position on a flat surface.
Electrostatic discharge can damage or destroy the components in the server.
During this entire procedure, use an anti-static wrist strap to discharge any
static electricity you may be carrying.
1. Check the packing list on the side of the carton to make sure that you have received all the
items.
2.
Make sure that you have a Phillips screwdriver.
Step 2: Network Connection
The MicroMAS requires a static IP Address. The MicroMAS and the CIX (LCTU card) should be the
same network segment.
Since MicroMAS-H has a VoIP connection to the LIPU, then the supporting LIPU must have an IP
address that can be successfully pinged by MicroMAS.
A LIPU card’s IP Address must be accessible by all IP devices (IPT, MicroMAS). If IPT stations are
going to be placed on the public internet or Strata Net IP will be run on the public network without
a VPN, the LIPU should have a public IP address. The MicroMAS and CIX must be physically
installed first. Connect up the MicroMAS. Insert the IP circuit cards into the CIX cabinets. Connect
the IP cables. When all of the cables are connected proceed to the next step of setup.
Step 3: Verify PC Is Operational
Notes
•
Steps 2~5 are required only if you have purchased a Voice board. They are not required for
ACD, etc.
•
This step verifies the unit is operational before installing voice boards.
1. Set the Voltage Selector Switch, located on the back panel, to an input power source of either
115VAC default or 220VAC (50-60 Hz), depending upon the available input power.
2.
Plug-in the power cable to the rear of the unit and to the UPS.
3.
Connect the monitor, keyboard and mouse. See
for the monitor, keyboard
and mouse connections on the MicroMAS.
4.
Power up the unit. If the Windows® XP logon screen does not display, check the connections.
At this point the installation is partitioned.
•
If you are installing a MicroMAS-D, that uses Dialogic analog port voice boards for
connectivity to the CIX or installing a Fax modem card, proceed to the next step.
•
If you are installing a MicroMAS-H, that uses HMP for IP connectivity to a CIX LIPU card,
proceed to step 13.
