Toshiba MMD-AP0186HP1-E Service Manual Download

Page: 7 / 104

– 7 –

WARNIG

General

Before starting to repair the air conditioner, read carefully through the Service Manual, and repair the

air conditioner by following its instructions.
Only qualified service person (*1) is allowed to repair the air conditioner.

Repair of the air conditioner by unqualified person may give rise to a fire, electric shocks, injury, water

leaks and / or other problems.
Do not use any refrigerant different from the one specified for complement or replacement.

Otherwise, abnormally high pressure may be generated in the refrigeration cycle, which may result in a

failure or explosion of the product or an injury to your body.
Only a qualified installer (*1) or qualified service person (*1) is allowed to carry out the electrical work

of the air conditioner.

Under no circumstances must this work be done by an unqualified individual since failure to carry out

the work properly may result in electric shocks and / or electrical leaks.
When the air conditioner is to be transported, installed, maintained, repaired or removed, wear

protective gloves and ‘safety’ work clothing.
To connect the electrical wires, repair the electrical parts or undertake other electrical jobs, wear gloves

to provide protection for electricians, insulating shoes and clothing to provide protection from electric

shocks. Failure to wear this protective gear may result in electric shocks.
Electrical wiring work shall be conducted according to law and regulation in the community and

installation manual. Failure to do so may result in electrocution or short circuit.
Use wiring that meets the specifications in the Installation Manual and the stipulations in the local

regulations and laws. Use of wiring which does not meet the specifications may give rise to electric

shocks, electrical leakage, smoking and/or a fire.
Only a qualified installer (*1) or qualified service person (*1) is allowed to undertake work at heights

using a stand of 50 cm or more or to remove the intake grille of the indoor unit to undertake work.
When working at heights, use a ladder which complies with the ISO 14122 standard, and follow the

procedure in the ladder’s instructions.

Also wear a helmet for use in industry as protective gear to undertake the work.
Before working at heights, put a sign in place so that no-one will approach the work location,

before proceeding with the work. Parts and other objects may fall from above, possibly injuring a

person below. While carrying out the work, wear a helmet for protection from falling objects.
When executing address setting, test run, or troubleshooting through the checking window on the

electric parts box, put on insulated gloves to provide protection from electric shock. Otherwise you may

receive an electric shock.

Do not touch the aluminum fin of the outdoor unit.

You may injure yourself if you do so. If the fin must be touched for some reason, first put on protective

gloves and safety work clothing, and then proceed.
Do not climb onto or place objects on top of the outdoor unit.

You may fall or the objects may fall off of the outdoor unit and result in injury.
Use forklift to carry in the air conditioner units and use winch or hoist at installation of them.
When transporting the air conditioner, wear shoes with protective toe caps, protective gloves and other

protective clothing.
When transporting the air conditioner, do not take hold of the bands around the packing carton.

You may injure yourself if the bands should break.
Be sure that a heavy unit (10 kg or heavier) such as a compressor is carried by

four

persons.

This air conditioner has passed the pressure test as specified in IEC 60335-2-40 Annex EE.

Before troubleshooting or repair work, check the earth wire is connected to the earth terminals of the main unit,

otherwise an electric shock is caused when a leak occurs.If the earth wire is not correctly connected,

contact an electric engineer for rework.
After completing the repair or relocation work, check that the ground wires are connected properly.
Be sure to connect earth wire. (Grounding work) Incomplete grounding causes an electric shock.

Do not connect ground wires to gas pipes, water pipes, and lightning rods or ground wires for

telephone wires.

Check earth

wires.