9
-4. Check Codes Displayed on Remote Control and
SMMS-e Outdoor Unit (7-Segment Display on I/F
Board) and Locations to Be Checked
For other types of outdoor units, refer to their own service manuals.
Check code
Location
of
detection
Description
System status
Trouble
detection
condition(s)
Check items (locations)
Main
remote
control
Outdoor 7-segment display
Check
code
Sub-code
E01 –
–
Remote
control
Indoor-remote
control
communication
trouble
(detected at
remote
control end)
Stop of
corresponding
unit
Communication between
indoor P.C. board and
remote control is disrupted.
• Check remote control
inter-unit tie cable (A/B).
• Check for broken wire or
connector bad contact.
• Check indoor power
supply.
• Check for defect in indoor
P.
C. board.
• Check remote control
address settings
(when two remote control
are in use).
• Check remote control
P.
C. board.
E02 –
–
Remote
control
Remote
control
transmission
trouble
Stop of
corresponding
unit
Signal cannot be
transmitted from remote
control to indoor unit.
• Check internal
transmission circuit of
remote control.
--- Replace remote
control as necessary.
E03 –
–
Indoor
unit
Indoor-remote
control
communication
trouble
(detected at
indoor end)
Stop of
corresponding
unit
There is no communication
from remote control
(including wireless) or
network adaptor.
• Check remote control
and network adaptor
wiring.
E04 –
–
Indoor
unit
Indoor-outdoor
communication
circuit
trouble
(detected at
indoor end)
Stop of
corresponding
unit
Indoor unit is not receiving
signal from outdoor unit.
• Check order in which
power was turned on for
indoor and outdoor units.
• Check indoor address
setting.
• Check indoor-outdoor tie
cable.
• Check outdoor
terminator
resistor
setting (SW30,
Bit 2).
E06
E06
I/F
Signal lack
of
indoor unit
All stop
Indoor unit initially
communicating normally fails
to return signal for specified
length of time.
• Check power supply to
indoor unit.
(Is power turned on?)
• Check connection of
indoor-outdoor
communication cable.
• Check connection of
communication connectors
on indoor P.C. board.
• Check connection of
communication connectors
on outdoor P.C. board.
• Check for defect in indoor
P.C. board.
• Check for defect in outdoor
P.C. board (I/F).
– E07
–
I/F
Indoor-outdoor
communication
circuit
trouble
(detected at
outdoor end)
All stop
Signal cannot be transmitted
from outdoor to indoor units
for 30 seconds continuously.
• Check outdoor
terminator
resistor
setting (SW30,
Bit 2).
• Check connection of
indoor-outdoor
communication circuit.
No. of indoor units from
which signal is received
normally
- 59 -
