– 40 –
Confirming the indoor unit addresses and the position of an indoor unit using the remote
controller
Confirming the numbers and positions of indoor units
To see the indoor unit address of an indoor unit which you know the position of
When the unit is individual (the indoor unit is paired with a wired remote controller one-to-one),
or it is a group-controlled one.
Starts
running
2
1
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
(Execute it while the units are running.)
1
Push the
ON / OFF
button if the units stop.
2
Push the
UNIT LOUVER
button (left side of the button).
A unit numbers
1-1
1-1
1-1
1-1
1-1
is indicated on the LCD (it will disappear after a few seconds). The indicated number shows the
system address and indoor unit address of the unit.
When 2 or more indoor units are connected to the remote controller (group-controlled units), a number of other
connected units appears each time you push the
UNIT LOUVER
button (left side of the button).
