SMMS High-Wall Type
Owner’s Manual
– 14 –
EN
5.
Adjusting Clock
Setting the clock
Before you start operating the air conditioner, set
the clock of the remote controller using the
procedures given in this section. The clock panel
on the remote controller will indicate the time
regardless of whether the air conditioner is in use or
not.
Initial setting
When batteries are inserted in the remote controller
the clock panel will indicate AM 0:00 and will flash.
1
TIMER
button
Push the TIMER button to set the current time.
Each push of the TIMER button changes the time in
one minute steps.
Pushing the TIMER button continually changes the
time in ten minute steps.
2
SET
SET
button
Push the SET
SET
button.
The current time is indicated and the clock starts.
Clock adjusting
1
CLOCK button
Push the CLOCK button.
The CLOCK display flashes.
2
TIMER button
Push the TIMER button to set the current time.
Each push of the TIMER button changes the time by
one minute.
Pushing the TIMER button continually changes the
time by ten minutes.
3
SET
SET
button
Push the SET
SET
button.
The current time is indicated and the clock starts.
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
FIX
SWING
MEMO
START/STOP
1
2
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
FIX
SWING
MEMO
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
FIX
MEMO
START/STOP
SWING
2
3
1
14-EN
High-Wall Type
