SMMS High-Wall Type
Owner’s Manual
– 22 –
EN
Memory / Preset Operation
Memorize the frequently used operation setting by
the MEMO button for convenience.
Start the air conditioner in the operation mode
which you want the remote control to memorize.
Push the button as follows while the air conditioner
is in operation.
1
MEMO button
Push this button briefly to standby memorizing the
setting.
All the icons currently displayed except for the clock
display and
mark flashes.
2
MEMO button
Push and hold the MEMO button for more than 3
seconds while the display flashes.
The
mark is indicated and the setting is
memorized.
• If the MEMO button is not pushed within 3 seconds
or if another button is pushed, the MEMORY
setting is cancelled.
• Operation modes which can be memorized with
the MEMO button are MODE, Temperature, FAN,
TIMER and Hi POWER.
To operate the air conditioner with the setting
memorized by the MEMO button.
1
PRESET button
Push the PRESET button. The setting memorized
with the MEMO button will be indicated and the air
conditioner operates with regards to the setting.
• The
lamp (green) on the display panel of the
indoor unit goes on, and operation starts after
approximately 3 minutes.
• Initial setting:
MODE
: AUTO
Temperature : 22
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
1, 2
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
1
22-EN
High-Wall Type
