11
TOSHIBA 1108150401_EN
EN
Hi POWER OPERATION
High power (Hi POWER)
•
The Hi POWER (high power operation) mode automatically controls
room temperature, air flow and operation mode so that the room is
quickly cooled in summer and warmed in winter. (
see page 15.)
Setting Hi POWER mode
1
1
1
1
1
Hi POWER button
Press the Hi POWER button after starting any operation. At the same
time, the “Hi POWER” mark on the remote control is indicated.
Canceling Hi POWER mode
1
1
1
1
1
Hi POWER button
Press the Hi POWER button once again.
At the same time, the “Hi POWER” mark on the remote control goes out.
CAUTION
•
The Hi POWER mode cannot be activated in the DRY and FAN
ONLY operation and when the ON TIMER operation is reserved.
•
Hi POWER mode is not available for group control.
(
see page 7.) When Hi POWER is transmitted to the Header
indoor unit, the receiving sound is heard but the Hi POWER mode will
not be performed. Please cancel the Hi POWER mode.
TIMER OPERATION
Use the wired remote controller for timer setting if it is also in use.
ON timer and OFF timer
Setting TIMER
1
1
1
1
1
ON/OFF TIMER button
Press the ON or OFF TIMER buttons as required.
•
The previous timer setting is displayed and flashes along with
ON/OFF TIMER display.
2
2
2
2
2
TIMER button
Press the TIMER button.
Set the timer to the desired time.
Each press of the TIMER button changes the time in ten minute steps.
Pressing the TIMER button continually changes the time in one hour step.
3
3
3
3
3
SET
SET
button
Press the SET
SET
button to set the timer.
The timer time is indicated and the timer starts.
Canceling TIMER
4
4
4
4
4
CLR
CLR
button
Press the CLR
CLR
button to cancel the timer setting.
Once you select the timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions when you simply press the ON/OFF button
of the remote control.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section “SETTING THE CLOCK” on page 6 to set the clock, and then set the timer.
CAUTION
•
When you select the timer operation, the remote control automatically transmits the timer signal to the indoor
unit at the specified time. Therefore, keep the remote control in a location where it can transmit the signal to
the indoor unit properly.
•
If you do not press the SET
SET
button within 30 seconds after setting the time, the setting will be cancelled.
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
A
1
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
1
2
3
4
01(EN)_1108150401 P08-13
05.1.17, 12:20
11
