14
TOSHIBA 1108150401_EN
EN
ADJUSTING AIR FLOW DIRECTION
•
Adjust the air flow direction properly. Otherwise, it might cause
discomfort and make the room temperature uneven.
•
Adjust the vertical air flow using the remote control.
•
Adjust the horizontal air flow manually.
Adjust the vertical air flow
The air conditioner automatically adjusts the vertical air flow direction in
accordance with the operating conditions when AUTO or A mode is selected.
To set the air flow direction you desire
Perform this function when the air conditioner is in operation.
1
1
1
1
1
FIX button
Keep pressing or pressing briefly the FIX button on the
remote control to move the flap in the desired direction.
•
In subsequent operations, the vertical air flow is automatically
set in the direction to which you adjusted the flap using the
FIX button.
To automatically swing the air flow direction
Perform this function when the air conditioner is in operation.
1
1
1
1
1
SWING button
Press the SWING button on the remote control.
•
To stop the function, press the SWING button.
Adjust the horizontal air flow
Preparation:
•
Take hold of the lever on the horizontal air flow
flap and move them to adjust the air flow
direction as required.
•
You can adjust the air flow at the left, and right
locations of the flap.
•
The FIX and SWING buttons will be disabled when the air conditioner
is not in operation (including when the ON TIMER is set).
•
Do not operate the air conditioner for long hours with the air flow
direction set downward during the cooling or dry operation.
Otherwise, condensation may occur on the surface of the vertical air
flow flap and cause dew dripping.
•
Do not move the vertical air flow flap manually. Always use the
FIX button.
If you move the flap manually, it may malfunction during operation.
If the flap malfunctions, stop the air conditioner once, and restart.
•
When the air conditioner is started immediately after it was stopped,
the vertical air flow flap might not move for 10 seconds or so.
•
Flap operation is limited when performing group control.
(
see page 7.)
CAUTION
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
1
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
1
Operating angle of vertical airflow flap will be different during cooling,
dry and heating operation.
NOTE
01(EN)_1108150401 P14
05.1.17, 12:17
14
