Toshiba MMU-AP00124MH-E Installation Manual Download

Page: 35 / 52

– 34 –

Connecting drain pipe

• Connect a hard socket (procured locally) to the hard

socket of the attached supplied flexible hose.

• Connect a drain pipe (procured locally) to the

connected hard socket.

REQUIREMENT

• Connect hard vinyl chloride pipes securely using an

adhesive for vinyl chloride to avoid water leakage.

• It takes some time until the adhesive is dried and

hardened (refer to the manual of the adhesive). Do not
apply stress to the joint with the drain pipe during this
time period.

Drain up

When a down-gradient cannot be secured for the
drainpipe, drain-up piping is possible.
• The height of the drain pipe must be 850 mm or less

from the bottom of the ceiling.

• Take the drain pipe out of the drain pipe joint with the

indoor unit in 300 mm or less, and bend up the pipe
vertically.

• Immediately after the pipe is bent up vertically, lay

the pipe making a down-gradient.

• Set downward grading immediately after raising up

vertically.

Check the draining

In the test run, check that water drain is properly
performed and water does not leak from the connecting
part of the pipes.
Check draining also when installed in heating period.
By using a pitcher or hose, pour water (1500 - 2000 cc)
into the discharge port before installation of the ceiling
panel.
Pour water gradually so that water does not spread on
the motor of the drain pump.

CAUTION

Pour water gently so that it does not spread around
inside the indoor unit, which may cause a malfunction.

Drain pipe

connecting port

(Transparent)

Adhesive inhibited:

Use the attached flexible hose and hose band for

connecting the drain hose to the clear drain socket.

If applying the adhesive, socket will be damaged and

cause water leakage.

Align the attached hose band to

the end of hose, set the

tightening position upward, and

then tighten it.

Flexible hose

(Accessory)

Socket for VP25 vinyl chloride pipe

(To be local procure)

Drain pipe

connecting port

(Hard socket)

VP25 vinyl chloride pipe

(To be local procure)

Attached hose

band

Attached flexible hose

Soft socket

Hard socket

Socket for VP25

(To be local procure)

VP25 vinyl chloride

pipe (To be local

procure)

or un

Indo

ing

627.

5 m

or l

Underside of ceiling

Indoor unit

300 mm or less

0 mm or

• After the electric work has finished, pour water

during COOL mode operation.

• If the electric work has not yet finished, pull out the

float switch connector (CN34: Red) from the
electrical control box, and check draining by plugging
the single phase 220 - 240 V power to the terminal
blocks R(L) and S(N).
If doing so, the drain pump motor operates.

• Test water drain while checking the operation sound

of the drain pump motor.
(If the operation sound changes from continuous
sound to intermittent sound, water is normally
drained.)
After the check, the drain pump motor runs,
connecting the float switch connector.
(In case of check by pulling out the float switch
connector, be sure to return the connector to the
original position.)

Perform heat insulating

• As shown in the figure, cover the flexible hose and

hose band with the attached heat insulator up to the
bottom of the indoor unit without gap.

• Cover the drain pipe seamlessly with a heat insulator

to be procured locally so that it overlaps with the
attached heat insulator of the drain connecting
section.

* Direct the slits and seams of the heat insulator

upward to avoid water leakage.

Air

discharge area

Check panel

Insert the leading part of the hose

between the heat exchanger and