Toshiba
– 27 –
SMMS 4-way Air Discharge Cassette Type
Installation Manual
How to cancel louver lock
Set the wind direction to “
0000
” of the louver lock
setup procedure above.
• When the setting is canceled,
goes out.
Other operations are the same as those in
“How to set up louver lock (No swing)”.
Group control
In a group control, a remote controller can control
up to maximum 8 units.
• For wiring procedure and wiring method of the
individual line (Identical refrigerant line) system,
refer to “Electric work” in this Manual.
• Wiring between indoor units in a group is
performed in the following procedure.
Connect the indoor units by connecting the
remote controller inter-unit wires from the
remote controller terminal blocks (A/B) of the
indoor unit connected with a remote controller
to the remote controller terminal blocks (A/B) of
the other indoor unit.
(Non-polarity)
• For address setup, refer to the Installation
Manual attached to the outdoor unit.
Remote controller sensor
The temperature sensor of the indoor unit senses
room temperature usually. Set the remote
controller sensor to sense the temperature around
the remote controller.
Select items following the basic operation
procedure (
1
→
2
→
3
→
4
→
5
→
6
).
• Specify [32] for the CODE No. in Procedure
3
.
• Select the following data for the SET DATA in
Procedure
4
.
When
flashes, the remote controller sensor is
defective.
Select the SET DATA [0000] (not used) or replace
the remote controller.
SET DATA
0000
0001
Remote controller
sensor
Not used
(factory setting)
Used
0000
Setting data
27-EN
+00EH99863501_6L_SMMS_4-way_IM1_printOnly.book Page 27 Thursday, September 11, 2008 9:29 AM
Summary of Contents for MMU-AP0092H
Page 38: ... 217 MEMO ...
