41
Right/Left air direction adjustment
To change the air outlet direction to the right or left side, set the vertical louver located behind the horizontal
louver to the desired direction.
INFORMATION
• If cooling operation is performed with a donwards discharge,
dew may form on the surface of the cabinet or the horizontal
louver resulting in possible dripping.
• If heating operation is performed with a horizontal discharge,
the room temperature may not be equal i.e. there may be a
large variance between one side of the room with the other.
High Wall Type
Adjustment of air Flow direction Upwards/Downwards
[In Cooling operation]
In cooling operation, use the horizontal louver with a horizontal set
point so that the cold air diffuses the whole room.
[In Heating operation]
In heating operation, use the horizontal louver with a downwards set
point so that the hot air blows towards the floor.
REQUIREMENT
• If cooling operation is performed with the louver set at a down-
wards position, dew may form on the surface of the cabinet or
the horizontal louver resulting in possible dripping.
• If heating operation is performed with the louver set in a horizon-
tal position, the room temperature may not be equal i.e. there
may be a large variance between one side of the room with the
other.
• Do not move the horizontal louver directly with your hands;
otherwise a fault maybe caused. Select the direction of the
horizontal louver using the
SWING/FIX
button on the remote controller.
The horizontal louver will not stop immediately even if the switch
is pushed. Note pushing the switch again when the required
louver direction has been reached will stop the louver.
Adjustment of air Flow direction rightwards/leftwards
To change the air outlet direction to the right or left side, set the
vertical louver located behind the horizontal louver to the desired
direction.
Setup of air direction and swinging
1H series: Refer to the description of
“2-way Air Discharge Cassette Type”.
2H series: Refer to the description of “Under Ceiling Type,
1-way Air Discharge Cassette Type (2SH Series)”.
Floor Standing Cabinet Type
[In Cooling operation]
In cooling operation, set the air outlet louver with a horizontal
set point so that the cold air diffuses the whole room.
[In Heating operation]
In heating operation, set the air outlet louver with a down-
wards set point so that the hot air blows towards the floor.
How to change the air outlet port
Change the air outlet port using the following procedure.
1
Remove the two fixing screws on the air outlet
port.
(The fixing screws are reused.)
2
Remove the discharge port, by pushing up on the
rear side, to a point where you can remove it from
the rear clip.
3
Lift the air outlet port upwards
and remove it.
4
Reverse the air outlet port and attach it to the
main unit.
Pay attention so that four claw hooks (two at rear and
two at the lower sides) are hooked on the mounting
position.
5
Be sure to tighten the air outlet port with the
removed fixing screws so that the air outlet port
does not come off.
