MR-2019/2018/MY-1034 DISASSEMBLY AND ASSEMBLY 5 - 3
(2)
Drive unit removal
1) Remove three screws.
2) Remove the drive unit.
(3)
Drive motor removal
1) Remove the gear.
2) Remove two screws.
3) Remove the drive motor.
■
Note for reassembly
Connect the connectors according to the arrow indication marked
on the motor mounting plate.
G. Shutter solenoid
(1)
Shutter solenoid unit removal
1) Remove the harness from the edge saddle.
2) Remove one screw.
3) Remove the shutter solenoid unit.
■
Note for reassembly
Install the paper feed solenoid under the state where the projection
of the paper feed planet arm is lower than the paper feed solenoid
lever.
(2)
Shutter solenoid removal
1) Remove the paper feed solenoid spring from the shutter sole-
noid.
2) Remove the paper feed solenoid lever.
■
Note for reassembly
When assembling, use care so that the paper feed solenoid spring
does not extend out of the paper feed solenoid lever.
H. Pickup roller, take-up roller
(1)
Paper feed unit removal
1) Remove the E-ring.
2) Slide the bearing.
3) Remove the stopper arm.
4) Release the paper feed shaft pressure release spring.
5) Remove the paper feed unit.
6) Remove the paper feed shaft release arm.
(2)
Parts removal
1) Remove the E-ring.
2) Remove the resin E-ring.
3) Slide the shaft.
4) Remove the spring pin.
1
1
2
1
3
2
1
2
3
1
2
1
2
1
3
4
5
6
3
1
4
2
