General Precautions for Installation/Servicing/Maintenance
for the MR-2018/2019 and MY-1034
The installation and service should be done by a qualified service
technician.
1. When installing the MR-2018/2019 and MY-1034 to the Equipment, be sure to follow the instructions
described in the "Unpacking/Set-Up Procedure for the MR-2018/2019 and MY-1034" booklet which
comes with each unit of the MR-2018/2019 and MY-1034.
2. The MR-2016/3017 should be installed by an authorized/qualified person.
3. Before starting installation, servicing or maintenance work, be sure to turn OFF and unplug the
equipment first.
4. When servicing or maintaining the MR-2018/2019 and MY-1034, be careful about the rotating or
operation sections such as gears, pulleys, sprockets, cams, belts, etc.
5. When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise
noted in this manual or other related materials. Be careful not to reassemble small parts such as
screws, washers, pins, E-rings, toothed washers to the wrong places.
6. Basically, the machine should not be operated with any parts removed or disassembled.
7. Delicate parts for preventing safety hazard problems (such as switches, sensors, etc. if any) should
be handled/installed/adjusted correctly.
8. Use suitable measuring instruments and tools.
9. During servicing or maintenance work, be sure to check the serial No. plate and other cautionary
labels (if any) to see if they are clean and firmly fixed. If not, take appropriate actions.
10.The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband,
because the ICs on it may be damaged due to static electricity. Before using the wrist band, pull out
the power cord plug of the equipment and make sure that there is no uninsulated charged objects in
the vicinity.
11.For the recovery and disposal of used MR-2018/2019 and MY-1034, consumable parts and packing
materials, follow the relevant local regulations or rules.
12.After completing installation, servicing and maintenance of the MR-2018/2019 and MY-1034, return
the MR-2018/2019 and MY-1034 to its original state, and check operation.
